Download Free Similitude Study Of Flexible Buried Arches Subjected To Blast Loads Book in PDF and EPUB Free Download. You can read online Similitude Study Of Flexible Buried Arches Subjected To Blast Loads and write the review.

The objective of the study was to investigate and verify model-to-prototype scaling relations for blast loaded buried arches that respond both elastically and inelastically. Four geometrically similar, semicircular aluminum alloy arches with 4-, 8-, 12-, and 36-inch diameters were buried in dense dry sand and subjected to air-blast-induced loads on the surface. The tests were conducted at the Large Blast Load Generator located at the U.S. Army Engineer Waterways Experiment Station. The results of two series of tests, each consisting of 3 repeated shots, ranging from 70 to 300 psi, are presented. Within the range of parameters investigated, the scaling of the dependent variables were adequately verified. These variables included acceleration, velocity, displacement, thrust, and bending moment. (Author).
The objective of the study was to investigate and verify model-to-prototype scaling relations for blast loaded buried arches that respond both elastically and inelastically. Four geometrically similar, semicircular aluminum alloy arches with 4-, 8-, 12-, and 36-inch diameters were buried in dense dry sand and subjected to air-blast-induced loads on the surface. The tests were conducted at the Large Blast Load Generator located at the U.S. Army Engineer Waterways Experiment Station. The results of two series of tests, each consisting of 3 repeated shots, ranging from 70 to 300 psi, are presented. Within the range of parameters investigated, the scaling of the dependent variables were adequately verified. These variables included acceleration, velocity, displacement, thrust, and bending moment. (Author).
Froude modeling, where strength and modulus properties and surface overpressure scale as the length scale, is a potential method for determining the structural response of underground protective structures at overpressures in excess of existing laboratory devices provided the strength and modulus properties can be adequately scaled. The results of this study indicated that Froude model tests on silo-type structures in dry sand under one-dimensional plane wave loading could predict the loading response of a prototype constructed using a length scale of three. The primary contribution of this study was to focus attention on the necessity of scaling the unloading soil moduli if Froude modeling is to successfully predict the time-history of a soil-structure system whenever the characteristics of the problem (loading, geometry, etc.) are such that unloading occurs in the soil.
The objectives of the investigation were to design and model test a blast-resistant reinforced concrete slab system serving as the roof of a basement shelter area. The slab system was designed to offer sufficient radiation and blast protection to insure a survival probability for its occupants of 85 to 95 percent for a fa 15-psi airblast overpressure loading. Static and dynamic tests were conducted on two 1/4-scale models of a prototype shelter. The prototype shelter, as designed, has a reinforced concrete flat slab roof consisting of three 18-foot spans in each direction supported by four interior columns and by a continuous wall around the perimeter. The model included the perimeter walls and different panel configurations which would influence the load-carrying capacity of the prototype structure. The slab system was designed using the empirical method of the 1963 American Concrete Institute Code with modifications to account for the dynamic loading effects. (Author).