Download Free Qc T 1170 2022 Translated English Of Chinese Standard Qc T 1170 2022 Qct1170 2022 Book in PDF and EPUB Free Download. You can read online Qc T 1170 2022 Translated English Of Chinese Standard Qc T 1170 2022 Qct1170 2022 and write the review.

This document specifies the terms and definitions, classification and marking, requirements, test methods, inspection rules, packaging, marking, transportation, storage, etc. of performance films for automotive glass. This document is applicable to the performance film, which is mounted on the inner surface of the motor vehicle window glass and the surface of the interior partition glass. The performance film mounted on the glass surface of other vehicles can use this standard as a reference.
This document specifies the main types and dimensions for tapped and male fitting in the matrix of pneumatic braking system of motor vehicle and towed vehicle. This document applies to the pneumatic braking system of motor vehicles and towed vehicles with air pressure below 2 MPa.
This document specifies the type, size, technical conditions of double end studs bm = 1.25d. This document is applicable to double end studs for automobiles, whose thread at the screw-in base end is ordinary coarse thread, transition fit thread, ordinary fine thread (thread specification is greater than M16), AND the thread at the screw-in nut end is ordinary coarse thread and ordinary fine thread.
This document specifies the terms and definitions, statistical scope, calculation methods of comprehensive water consumption for unit output of automobile products. This document is applicable to the calculation of comprehensive water consumption for unit output of automobile products.
This document specifies the terms and definitions, classification and marking, requirements, test methods, inspection rules and signs, packaging, transportation, storage, sample preparation methods, installation technical requirements of automobile paint protection films. This document is applicable to the protection film, which is pasted on the exterior paint surface of existing automobiles and auto parts. The protection film, which is pasted on the surface of other cars and parts, can refer to this document.
This document specifies the installation dimensions of the interface -- between the front end of the transmission assembly and the engine or drive motor, AND the interface -- between the rear end and the transmission components. This document applies to automotive mechanical transmission assemblies.
This document stipulates the classification, basic configuration, general requirements, test methods, inspection rules and marking, packaging, transportation, storage of coach toilets. This document applies to toilets used on coaches.
This document specifies the requirements, test methods, inspection rules and signs, packaging, transportation, storage of the seats of passenger vehicles. This document is applicable to passenger seats of categories M2 and M3 passenger vehicles. This document does not apply to the plastic seats, which are used in Class A and Class I passenger vehicles of category M2 and M3, as well as student seats of special school buses.