Download Free Evaluation Of A New Bridge Formula For Regulation Of Truck Weights Book in PDF and EPUB Free Download. You can read online Evaluation Of A New Bridge Formula For Regulation Of Truck Weights and write the review.

The current bridge formula, Federal Bridge Formula B (BFB), established in 1974 to protect bridges against excessive overstress, is very restrictive on long combination vehicles due to an 80,000 lb gross vehicle weight limit. Without this limit the formula will not be able to protect bridges in the cases of longer trucks. A formula developed by the Texas Transportation Institute (T.T.I.) called the TTI-HS20 Formula addresses these issues. This formula, developed especially for bridges designed for the HS-20 truck, eliminates the need for the 80,000 lb limit. A generic formula developed to protect H15 and HS-20 bridges (James et al.,1986) was evaluated in a previous study (James and Zhang, 1991). The approach to evaluating the TTI-HS20 Formula follows the approach outlined in James and Zhang,1991. Information was collected on two important elements: a set of test bridges representative of the lightest continuous bridges, and a set of test truck configurations representative of real truck traffic with a focus on long combination vehicles. Critical weights of the selected trucks for the representative bridges are calculated and plotted against the TTI-HS 20 formula and other proposed formulas. A final recommendation as to whether this formula should be adopted nationwide is made.
TRB Special Report 267 - Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles recommends the creation of an independent public organization to evaluate the effects of truck traffic, pilot studies of new truck designs, and a change in federal law authorizing states to issue permits for operation of larger trucks on the Interstates. In 1991, Congress placed a freeze on maximum truck weights and dimensions. Some safety groups were protesting against the safety implications of increased truck size and weight, and the railroads were objecting to the introduction of vehicles they deemed to have an unfair advantage. Railroads, unlike trucking firms, must pay for the capital costs of their infrastructure. The railroads contend that large trucks do not pay sufficient taxes to compensate for the highway damage they cause and the environmental costs they generate. Although Congress apparently hoped it had placed a cap on maximum truck dimensions in 1991, such has not proven to be the case. Carriers operating under specific conditions have been able to seek and obtain special exceptions from the federal freeze by appealing directly to Congress (without any formal review of the possible consequences), thereby encouraging additional firms to seek similar exceptions. In the Transportation Equity Act for the 21st Century, Congress requested a TRB study to review federal policies on commercial vehicle dimensions. The committee that undertook the study that resulted in Special Report 267 found that regulatory analyses of the benefits and costs of changes in truck dimensions are hampered by a lack of information. Regulatory decisions on such matters will always entail a degree of risk and uncertainty, but the degree of uncertainty surrounding truck issues is uunusually high and unnecessary. The committee concluded that the uncertainty could be alleviated if procedures were established for carrying out a program oof basic and applied research, and if evaluation and monitoring were permanent components of the administration of trucking regulations. The committee recommended immediate changes in federal regulations that would allow for a federally supervised permit program. The program would permit the operation of vehicles heavier than would normally be allowed, provided that the changes applied only to vehicles with a maximum weight of 90,000 pounds, double trailer configurations with each trailer up to 33 feet, and an overall weight limit governed by the federal bridge formula. Moreover, enforcement of trucks operating under such a program should be strengthened, and the permits should require that users pay the costs they occasion. States should be free to choose whether to participate in the permit program. Those that elected to do so would be required to have in place a program of bridge management, safety monitoring, enforcement, and cost recovery, overseen by the federal government. The fundamental problem involved in evaluating proposals for changes in truck dimensions is that their effects can often only be estimated or modeled. The data available for estimating safety consequences in particular are inadequate and probably always will be. Thus, the committee that conducted this study concluded that the resulting analyses usually involve a high degree of uncertainty. What is needed is some way to evaluate potential changes through limited and carefully controlled trials, much as proposed new drugs are tested before being allowed in widespread use. The committee recommended that a new independent entity be created to work with private industry in evaluating new concepts and recommending changes to regulatory agencies. Limited pilot tests would be required, which would need to be carefully designed to avoid undue risks and ensure proper evaluation. Special vehicles could be allowed to operate under carefully controlled circumstances, just as oversize and overweight vehicles are allowed to operate under special permits in many states. Changes in federal laws and regulations would be required to allow states to issue such permits on an expanded network of highways, under the condition that a rigorous program of monitoring and evaluation be instituted.Special Report 269 Summary
TRB Special Report 267 - Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles recommends the creation of an independent public organization to evaluate the effects of truck traffic, pilot studies of new truck designs, and a change in federal law authorizing states to issue permits for operation of larger trucks on the Interstates. In 1991, Congress placed a freeze on maximum truck weights and dimensions. Some safety groups were protesting against the safety implications of increased truck size and weight, and the railroads were objecting to the introduction of vehicles they deemed to have an unfair advantage. Railroads, unlike trucking firms, must pay for the capital costs of their infrastructure. The railroads contend that large trucks do not pay sufficient taxes to compensate for the highway damage they cause and the environmental costs they generate. Although Congress apparently hoped it had placed a cap on maximum truck dimensions in 1991, such has not proven to be the case. Carriers operating under specific conditions have been able to seek and obtain special exceptions from the federal freeze by appealing directly to Congress (without any formal review of the possible consequences), thereby encouraging additional firms to seek similar exceptions. In the Transportation Equity Act for the 21st Century, Congress requested a TRB study to review federal policies on commercial vehicle dimensions. The committee that undertook the study that resulted in Special Report 267 found that regulatory analyses of the benefits and costs of changes in truck dimensions are hampered by a lack of information. Regulatory decisions on such matters will always entail a degree of risk and uncertainty, but the degree of uncertainty surrounding truck issues is uunusually high and unnecessary. The committee concluded that the uncertainty could be alleviated if procedures were established for carrying out a program oof basic and applied research, and if evaluation and monitoring were permanent components of the administration of trucking regulations. The committee recommended immediate changes in federal regulations that would allow for a federally supervised permit program. The program would permit the operation of vehicles heavier than would normally be allowed, provided that the changes applied only to vehicles with a maximum weight of 90,000 pounds, double trailer configurations with each trailer up to 33 feet, and an overall weight limit governed by the federal bridge formula. Moreover, enforcement of trucks operating under such a program should be strengthened, and the permits should require that users pay the costs they occasion. States should be free to choose whether to participate in the permit program. Those that elected to do so would be required to have in place a program of bridge management, safety monitoring, enforcement, and cost recovery, overseen by the federal government. The fundamental problem involved in evaluating proposals for changes in truck dimensions is that their effects can often only be estimated or modeled. The data available for estimating safety consequences in particular are inadequate and probably always will be. Thus, the committee that conducted this study concluded that the resulting analyses usually involve a high degree of uncertainty. What is needed is some way to evaluate potential changes through limited and carefully controlled trials, much as proposed new drugs are tested before being allowed in widespread use. The committee recommended that a new independent entity be created to work with private industry in evaluating new concepts and recommending changes to regulatory agencies. Limited pilot tests would be required, which would need to be carefully designed to avoid undue risks and ensure proper evaluation. Special vehicles could be allowed to operate under carefully controlled circumstances, just as oversize and overweight vehicles are allowed to operate under special permits in many states. Changes in federal laws and regulations would be required to allow states to issue such permits on an expanded network of highways, under the condition that a rigorous program of monitoring and evaluation be instituted.Special Report 269 Summary
Evaluation, repair and rehabilitation of bridges are increasingly important topics in the effort to deal with the deteriorating infrastructure. For example, in the United States about 40 percent of the nation's 570,000 bridges are classified, according to the Federal Highway Administra tion's (FHW A) criteria, as deficient and in need of rehabilitation and replacement. In other countries the situation is similar. FHW A estimates the cost of a bridge replacement and reha bilitation program at 50 billion dollars. The major factors that have contributed to the present situation are: the age, inadequate maintenance, increasing load spectra and environmental contamination. The deficient bridges are posted, repaired or replaced. The disposition of bridges involves clear economical and safety implications. To avoid high costs of replacement or repair, the evaluation must accurately reveal the present load carrying capacity of the struc ture and predict loads and any further changes in the capacity (deterioration) in the applicable time span. Accuracy of bridge evaluation can be improved by using the recent developments in bridge diagnostics, structural tests, material tests, structural analysis and probabilistic methods. There is a need for an international exchange of advanced experience to increase the research effi ciency. The Workshop is organized on the premise that the exchange of existing American and European experience in the area of bridge evaluation, repair and rehabilitation is beneficial for both parties involved.
This demonstration project allowed Wisconsin Dept. of Transportation to test the overall performance of Bridge weigh in motion equipment as well as develop an entirely new comprehensive and representative truck weight database.
TRB Special Report 267 - Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles recommends the creation of an independent public organization to evaluate the effects of truck traffic, pilot studies of new truck designs, and a change in federal law authorizing states to issue permits for operation of larger trucks on the Interstates. In 1991, Congress placed a freeze on maximum truck weights and dimensions. Some safety groups were protesting against the safety implications of increased truck size and weight, and the railroads were objecting to the introduction of vehicles they deemed to have an unfair advantage. Railroads, unlike trucking firms, must pay for the capital costs of their infrastructure. The railroads contend that large trucks do not pay sufficient taxes to compensate for the highway damage they cause and the environmental costs they generate. Although Congress apparently hoped it had placed a cap on maximum truck dimensions in 1991, such has not proven to be the case. Carriers operating under specific conditions have been able to seek and obtain special exceptions from the federal freeze by appealing directly to Congress (without any formal review of the possible consequences), thereby encouraging additional firms to seek similar exceptions. In the Transportation Equity Act for the 21st Century, Congress requested a TRB study to review federal policies on commercial vehicle dimensions. The committee that undertook the study that resulted in Special Report 267 found that regulatory analyses of the benefits and costs of changes in truck dimensions are hampered by a lack of information. Regulatory decisions on such matters will always entail a degree of risk and uncertainty, but the degree of uncertainty surrounding truck issues is uunusually high and unnecessary. The committee concluded that the uncertainty could be alleviated if procedures were established for carrying out a program oof basic and applied research, and if evaluation and monitoring were permanent components of the administration of trucking regulations. The committee recommended immediate changes in federal regulations that would allow for a federally supervised permit program. The program would permit the operation of vehicles heavier than would normally be allowed, provided that the changes applied only to vehicles with a maximum weight of 90,000 pounds, double trailer configurations with each trailer up to 33 feet, and an overall weight limit governed by the federal bridge formula. Moreover, enforcement of trucks operating under such a program should be strengthened, and the permits should require that users pay the costs they occasion. States should be free to choose whether to participate in the permit program. Those that elected to do so would be required to have in place a program of bridge management, safety monitoring, enforcement, and cost recovery, overseen by the federal government. The fundamental problem involved in evaluating proposals for changes in truck dimensions is that their effects can often only be estimated or modeled. The data available for estimating safety consequences in particular are inadequate and probably always will be. Thus, the committee that conducted this study concluded that the resulting analyses usually involve a high degree of uncertainty. What is needed is some way to evaluate potential changes through limited and carefully controlled trials, much as proposed new drugs are tested before being allowed in widespread use. The committee recommended that a new independent entity be created to work with private industry in evaluating new concepts and recommending changes to regulatory agencies. Limited pilot tests would be required, which would need to be carefully designed to avoid undue risks and ensure proper evaluation. Special vehicles could be allowed to operate under carefully controlled circumstances, just as oversize and overweight vehicles are allowed to operate under special permits in many states. Changes in federal laws and regulations would be required to allow states to issue such permits on an expanded network of highways, under the condition that a rigorous program of monitoring and evaluation be instituted.Special Report 269 Summary