Download Free Design Of Very High Frequency Multirate Switched Capacitor Circuits Book in PDF and EPUB Free Download. You can read online Design Of Very High Frequency Multirate Switched Capacitor Circuits and write the review.

Design of Very High-Frequency Multirate Switched-Capacitor Circuits presents the theory and the corresponding CMOS implementation of the novel multirate sampled-data analog interpolation technique which has its great potential on very high-frequency analog frond-end filtering due to its inherent dual advantage of reducing the speed of data-converters and DSP core together with the specification relaxation of the post continuous-time filtering. This technique completely eliminates the traditional phenomenon of sampled-and-hold frequency-shaping at the lower input sampling rate. Also, in order to tackle physical IC imperfections at very high frequency, the state-of-the-art circuit design and layout techniques for high-speed Switched-Capacitor (SC) circuits are comprehensively discussed: -Optimum circuit architecture tradeoff analysis -Simple speed and power trade-off analysis of active elements -High-order filtering response accuracy with respect to capacitor-ratio mismatches -Time-interleaved effect with respect to gain and offset mismatch -Time-interleaved effect with respect to timing-skew and random jitter with non-uniformly holding -Stage noise analysis and allocation scheme -Substrate and supply noise reduction -Gain-and offset-compensation techniques -High-bandwidth low-power amplifier design and layout -Very low timing-skew multiphase generation Two tailor-made optimum design examples in CMOS are presented. The first one achieves a 3-stage 8-fold SC interpolating filter with 5.5MHz bandwidth and 108MHz output sampling rate for a NTSC/PAL CCIR 601 digital video at 3 V. Another is a 15-tap 57MHz SC FIR bandpass interpolating filter with 4-fold sampling rate increase to 320MHz and the first-time embedded frequency band up-translation for DDFS system at 2.5V. The corresponding chip prototype achieves so far the highest operating frequency, highest filter order and highest center frequency with highest dynamic range under the lowest supply voltage when compared to the previously reported high-frequency SC filters in CMOS.
This book proposes alternative switched capacitor techniques which allow the achievement of higher intrinsic analogue functional accuracy than previously possible in such application areas as analogue filter and ADC design. The validity of the concepts developed and analyzed in Switched-Capacitor Techniques for High-Accuracy Filter and ADC Design has been demonstrated in practice with the design of CMOS SC bandpass filters and algorithmic ADC stages.
After an overview of major scientific discoveries of the 18th and 19th centuries, which created electrical science as we know and understand it and led to its useful applications in energy conversion, transmission, manufacturing industry and communications, this Circuits and Systems History book fills a gap in published literature by providing a record of the many outstanding scientists, mathematicians and engineers who laid the foundations of Circuit Theory and Filter Design from the mid-20th Century. Additionally, the book records the history of the IEEE Circuits and Systems Society from its origins as the small Circuit Theory Group of the Institute of Radio Engineers (IRE), which merged with the American Institute of Electrical Engineers (AIEE) to form IEEE in 1963, to the large and broad-coverage worldwide IEEE Society which it is today. This second edition, commemorating the 75th anniversary of the Circuits and Systems Society, builds upon the first edition's success by expanding the scope of specific chapters, introducing new topics of relevance, and integrating feedback from readers and experts in the field, reflecting the evolving landscape of Circuits and Systems alongside the evolution of the professional society. Many authors from many countries contributed to the creation of this book, working to a very tight time schedule. The result is a substantial contribution to their enthusiasm and expertise, which it is hoped readers will find both interesting and useful. It is certain that in such a book, omission will be found, and in the space and time available, much valuable material had to be left out. It is hoped that this book will stimulate an interest in the marvelous heritage and contributions of the many outstanding people who worked in the Circuits and Systems area.
This is an introduction to noise, describing fundamental noise sources and basic circuit analysis, discussing characterization of low-frequency noise and offering practical advice that bridges concepts of noise theory and modelling, characterization, CMOS technology and circuits. The text offers the latest research, reviewing the most recent publications and conference presentations. The book concludes with an introduction to noise in analog/RF circuits and describes how low-frequency noise can affect these circuits.
High-speed Photodiodes in Standard CMOS Technology describes high-speed photodiodes in standard CMOS technology which allow monolithic integration of optical receivers for short-haul communication. For short haul communication the cost aspect is important , and therefore it is desirable that the optical receiver can be integrated in the same CMOS technology as the rest of the system. If this is possible then ultimately a singe-chip system including optical inputs becomes feasible, eliminating EMC and crosstalk problems, while data rate can be extremely high. The problem of photodiodes in standard CMOS technology it that they have very limited bandwidth, allowing data rates up to only 50Mbit per second. High-speed Photodiodes in Standard CMOS Technology first analyzes the photodiode behaviour and compares existing solutions to enhance the speed. After this, the book introduces a new and robust electronic equalizer technique that makes data rates of 3Gb/s possible, without changing the manufacturing technology. The application of this technique can be found in short haul fibre communication, optical printed circuit boards, but also photodiodes for laser disks.
IGH-SPEED Digital to Analog (D/A) converters are essential components in digi- Htal communication systems providing the necessary conversion of signals encoding information in bits to signals encoding information in their amplitude vs. time domain characteristics. In general, they are parts of a larger system, the interface, which c- sists of several signal conditioning circuits. Dependent on where the converter is located within the chain of circuits in the interface, signal processing operations are partitioned in those realized with digital techniques, and those with analog. The rapid evolution of CMOS technology has established implicit and explicite trends related to the interface, and in particular to the D/A converter. The implicit relationship comes via the growth of digital systems. First, it is a global trend with respect to all interface circuits that increasing operating frequencies of digital systems place a similar demand for the interface circuits. The second trend takes place locally within the int- face. Initially, the D/A converter was placed at the beginning of the interface chain, and all signal conditioning was implemented in the analog domain after the D/A conversion. The increasing ?exibility and robustness of digital signal processing shifted the D/A converter closer to the end point of the chain where the demands for high quality high frequency operation are very high.
This book deals with the analysis and design of CMOS current-mode circuits for data communications. CMOS current-mode sampled-data networks, i.e. switched-current circuits, are excluded. Major subjects covered in the book include: a critical comparison of voltage-mode and current-mode circuits; the building blocks of current-mode circuits: design techniques; modeling of wire channels, electrical signaling for Gbps data communications; ESD protection for current-mode circuits and more. This book will appeal to IC design engineers, hardware system engineers and others.
With a billion – soon to be two billion - cellular telephones in circulation, the next challenge is to make cellular radio functions adaptive to their environment. This book provides a comprehensive theoretical framework for optimizing performance, discussing joint optimization of Noise Figure and Input Intercept Point in receiver systems. Also examined are original techniques to optimize voltage controlled oscillators and low-noise amplifiers, minimizing power consumption while maintaining adequate system performance.
this book is not suitable for the bookstore catalogue
This book tackles challenges for the design of analog integrated circuits that operate from ultra-low power supply voltages (down to 0.5V). Coverage demonstrates the signal processing circuit and circuit biasing approaches through the design of operational transconductance amplifiers (OTAs). These amplifiers are then used to build analog system functions including continuous time filter and a sample and hold amplifier.