Download Free Constructing Temporary Sampling Platforms For Hydrologic Studies Book in PDF and EPUB Free Download. You can read online Constructing Temporary Sampling Platforms For Hydrologic Studies and write the review.

This paper presents instructions for constructing platforms that span the width of stream channels to accommodate the measurement of hydrologic parameters over a wide range of discharges. The platforms provide a stable, safe, noninvasive, easily constructed, and relatively inexpensive means for permitting data collection without wading in the flow. We have used the basic techniques described herein for building platforms on channels of small to medium size, up to 70 feet in width. Lightweight joists, commonly used in housing construction, form the primary structural support for the platform. The structures can be constructed by persons having only rudimentary knowledge of building practices and using simple tools. Cost estimates for materials range from $200 to $1,500 depending on the required length of structure. The platforms have been used successfully in measuring flow and sediment discharge in subalpine channels in Colorado and Wyoming during runoff events with 2 to 5 year return frequencies. They are quite stable and are safer than wading in channels with fast moving flow.
Turbidity threshold sampling uses real-time turbidity and river stage information to automatically collect water quality samples for estimating suspended sediment loads. The system uses a programmable data logger in conjunction with a stage measurement device, a turbidity sensor, and a pumping sampler. Specialized software enables the user to control the sampling process, plot and correct the data, and estimate suspended loads. This implementation guide describes the entire process, including instrumentation, installation, field procedures, software usage, data collection, laboratory methods, data interpretation, data reduction, and analysis.
A bedload trap is a portable sampler designed specifically for collecting gravel and cobble bedload (4 to 180 mm in diameter) in wadeable streams. Bedload traps consist of an aluminum frame with a 12 by 8 inch (0.3 by 0.2 m) opening to which a 3- to 5.5-ft (0.9 to 1.65 m) long trailing net is attached. Bedload traps are installed on ground plates that are anchored to the stream bottom with metal stakes. Traps do not have to be hand-held while sampling and have a large volumetric capacity. This permits collection of bedload over relatively long intervals, typically one hour per sample. In this document, we provide detailed guidelines for bedload trap construction and operation. We describe component parts and offer instructions for making the nets and assembling the sampler. Appropriate site selection and preparation are discussed as well as bedload trap installation, use, and maintenance. These guidelines also show how to process the collected bedload samples in the field and how to perform some of the typical calculations used in bedload evaluation.