Download Free Bus Truck Tractor Trailer Braking System Performance Book in PDF and EPUB Free Download. You can read online Bus Truck Tractor Trailer Braking System Performance and write the review.

This Recommended Practice provides a road test procedure for trucks and buses, to evaluate their compliance with Federal Motor Vehicle Safety Standard (FMVSS) 121; Air Brake Systems. Units of measure are English in lieu of metric to be consistent with FMVSS 121. This SAE Recommended Practice is intended as a guide toward industry practice and subject to change so as to keep pace with experience and technical advances. The usage of this recommend practice is limited to trucks and buses equipped with air brake systems with a GVWR greater than 10000 pounds.This document has been modified from SAE J1626-1 truck tractor to incorporate air brake equipped trucks and buses test procedure. The following sections were modified; changed all truck tractor wording to trucks and buses throughout the document, 3.1 definitions add trucks and buses, 3.5 was removed based on combination weight not applicable, 3.7.1 was removed based on tractor trailer combination not applicable and modified for trucks and buses, 3.13 remove unbraked control trailer not applicable, 6.8 removed control trailer reservoir not applicable, 6.13 and 8.2.2 removed the additional brake adjustment at the completion of the 500 snub burnish not applicable with trucks and buses, Section 7 test sequence was modified to follow FMVSS 121 truck and bus sequence, 8.1.3 truck and bus loading changes, 9.1.3, 10.1.2 and 11.1.2 removed brake adjustments not applicable, 9.1.1 corrected 20 foot cone spacing, 9.2.1 changed 35 to 30 mph and changed 44 to 40 mph, 9.2.2 corrected reference 3.9 to 3.8, 11.2.1a removed the word "only," Figure 5D removed LLVW, and corrected all header spacing between two-digit section number and header. Figures (data sheets) removed trailer ballast C.G. height measurement, bobtail proportional and fifth wheel height not applicable. SAE J1626-2 has been reaffirmed to comply with the SAE Five-Year Review policy.
This SAE Recommended Practice presents performance requirements for the brake systems of motor vehicles intended for roadway use and falling into the following classifications: Light trucks and buses: 6001-10,000 lb gvw Truck and bus: Over 10,000 lb gvw Combination of vehicles (towing vehicle over 10,000 lb gvw)Acceptable performance requirements are based on data obtained from applicable sections of SAE J786.
This SAE Recommended Practice presents performance requirements for the brake systems of motor vehicles intended for roadway use and falling into the following classifications: Light trucks and buses: 6001-10 000 lb (2700-4500 kg) gvw; Truck and bus: Over 10 000 lb (4500 kg) gvw; combination of vehicles towing vehicles over 10 000 lb (4500 kg) gvw. Acceptable performance requirements are based on data obtained from applicable sections of SAE J786a (March, 1978). The purpose of this recommended practice is to establish the minimum brake system performance requirements with regard to: 3.1 Stopping ability--of cold brakes, as affected by vehicle speed. 3.2 Stopping ability--of hot brakes, as affected by vehicle speed and duty cycle. 3.3 Pedal force (air pressure) requirements--maximum allowable. 3.4 Brake stability. 3.5 stopping ability and recovery of wet brakes. 3.6 Stopping ability of emergency brake system. 3.7 Brake effectiveness distribution for vehicles in combination.